Recommendations on Ford Dealers to flash my SJB

[gzbs197]

I am going to have to replace my SJB in my S197 due to the known issue of water leaking on it. Yesterday after driving in the rain - all the idiot lights came on , truck wont open off remote , door locks on remote wont work either but the car starts and runs just fine.

Ordered the new SJB from Tasca and will be here next week. I know the dealership will charge me @100 to 200 to flash the new one with my old codes. I dont really care for Troy Ford as they wanted $886 to replace it not including the new SJB.

Anyone deal with any Ford dealerships for service and recommend someone I can call and talk to about it? I will be taking the old and new SJB into them to flash , that is all I need. I will handle the removal and install as i am going to try and seal up where the water comes in so it doesnt happen again.

[redfirepearlgt]

Try Finishline. They have full flash capability through Ford as I recall. 513-831-9999. Don't forget to address that leak. Here are three videos on what causes some of the problem and ways to resolve it.

https://www.youtube.com/watch?v=iFapgCIsWwI
https://www.youtube.com/watch?v=8zEDM6FUebA
https://www.youtube.com/watch?v=chCTdgz6DgQ

[gzbs197]

Thanks!!! Yea I cleaned out the plugs and stuff the other day but I think the damage was already done. I was also going to try and seal it from the inside as well sealing around the wires and such.

[gzbs197]

Thanks for the tip on Finishline. I am going to take it down there to get it flashed. Cost is $100. I got my new SJB the other day.

[redfirepearlgt]

Can't beat that. Brian and the gang are good people.

[gzbs197]

Will be down there at 8am on Friday to get the SJB all swapped over. Had to wait till then as I am waiting on an adapter for my CAI to fit the GT500 TB I installed.