Final dyno pull on the white 14...

[redfirepearlgt]

Had a little fun with the video editor. Final numbers were about what I was expecting. Now its time to see what it will do when the track opens on the stock springs and shocks with 17" MT ET Radial II's on back.


https://youtu.be/KIi_aUeWkMA

[Yellow98Cobra]

Video was great. Must be one of them damn movies that makes you buy another ticket to see the ending. And the numbers where?

[redfirepearlgt]

Still street friendly based on the numbers. Down about 5% on numbers with same setup feeding through a 6R80 now and a 3.15 final compared to the 13 with the manual tranny and a 3.31 final. But that was to be expected. Guess I will get to see if this was all worth it.

[Rick93coupe]

I like it, what software did you use to do that?

[WCKDGT]

very cool video! what exhaust are you running?

[cyah92]

Can't wait to see it run chad.

[redfirepearlgt]

I like it, what software did you use to do that?

Corel Video Studio Pro X5. Its an older version and def not to the level of the higher end video editors but it's well under the $100 mark or V9 currently out. I had a longer version that used some chroma key effect but after reviewing all of that hit the floor.

[redfirepearlgt]

very cool video! what exhaust are you running?

Roush axle back with full cats and factory exhaust. Minimal drone under load inside as well.

[draggin50]

Sounds good! Cool video too!

[PKFIRE]

Your having too much fun with video editing. Cool video Chad!

[redfirepearlgt]

Long play sequel coming soon.

[86gt40]

On Jason's bad ass meter, that video is a 8.9. Awesome video! Nice job! Nice work on car. Nice!

[redfirepearlgt]

Thanks man. Means a lot.

[80 hate]

Very Cool!