Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
Anyone here mess with TunerStudio MS? [Archive] - StangBangerz Forums

PDA

View Full Version : Anyone here mess with TunerStudio MS?



supercab78
07-01-2014, 08:32 PM
I'm totally lost! I have my car running but it's running way to rich. I'm more of a points/carb type of guy and I don't know how to change the fuel cell settings in tunerstudio.

What I have is 1988 2.3 turbocoupe drive line in a 1931 Ford. I've installed a P.I.M.P. ECU (it's variation of megasquirt I believe) that is tuned with TunerStudio.

mustangjon
07-01-2014, 09:38 PM
I used it on my blown Lincoln but it's been several years. I would have to be hands on to help can hardly remember the layout... What part of Cincy are u in? I might be able to stop by sometime and see if I can help

Carl
07-01-2014, 11:47 PM
I'm running a PIMP on my 93 coupe(has an 88 TC engine).

To change them, you need to open Fuel Table 1, click on the cell(s) you want to change and either click the up or down arrow. Or you can click the equal button and type in the number you want.

supercab78
07-02-2014, 09:39 AM
Right now my AFR gauge on tunerstudio does not match what the "Fuel Table 1" is showing in any of the cells. Is that normal? I have 14point7 brand wideband O2 but I didn't get a gauge for the dash. Thought I could just use TuneStud gauge. TS gauge is staying close to 12.25/1, fuel tables are higher as you know.

Carl
07-02-2014, 11:27 AM
Did you calibrate the AFR table to the correct values for the WB?

supercab78
07-02-2014, 08:27 PM
Yes I entered them in <custom linear wideband> selection,

When my PC is "connected" to the pimp and car is running, when I go to < fuel settings> & < open AFR table 1> I see a dot floating at say 1000 RPM. That table is not a Live reading from the wide band is it?

Carl
07-02-2014, 08:56 PM
No, that table is the target. When you turn on auto tune, that is what TS will work towards.

Carl
07-02-2014, 09:53 PM
At idle you have to change the numbers yourself. I would never trust auto tune to make the idle cells correct.

supercab78
07-02-2014, 10:22 PM
I've read not to use auto tune until things are close and not to use it for idle either. I think my missing link is where I go to make the changes.

I will be sending you a PM also.

Carl
07-02-2014, 10:51 PM
Sounds good, I help you as much as I can. Been running pimp for almost 2 years now.