View Full Version : M2 Heads
blackstangs
10-18-2013, 12:15 PM
Has anyone ever used a set of heads ported by M2 Race Systems. I am building a 347 with Brodix Track 1 heads, they were ported by M2, bought car and engine not finished, M2 cant give me any soild info on what kind of headers to use. A stock 302 header is too small due to port job. The orignal exhaust bolt holes have been welded up and new ones drilled and tapped about a half inch further one each stud. I'll try to post a picture. Any help would be great.
TooFast98Cobra
10-18-2013, 12:48 PM
you need to buy a set of headers with 3" inline pattern. I had a set of T1 M2's few years ago. Nice heads and port work. On the end of the head/s it should have T1M2 stamped on them.
bbfstanger
10-18-2013, 12:49 PM
the new pattern is prob 3in on center, measure it.
m2 does good work
i ported a set of track ones and its pretty easy to get over 300cfm
blackstangs
10-18-2013, 03:43 PM
Thanks guys, yes from outside hole to outside hole is three inches. Does anyone make a set or am I going to have to buy a set of 3 inch flanges and make them.
TooFast98Cobra
10-18-2013, 05:12 PM
kooks has sets and you can also buy the flange.
bbfstanger
10-18-2013, 07:13 PM
i believe the 2 3/4 center to center is the n351 pattern.
kooks, accufab both make them.
i might have a set of flanges if your gonna modify a set or make your own.
TooFast98Cobra
10-18-2013, 07:44 PM
If the op doesn't want the flanges I would like to buy them .
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.