View Full Version : Looking for a cage!
SN95N/A
04-02-2013, 09:17 PM
Looking for a 10 point cage that I can weld in myself,if someone could send me too a website where I can order one,looking for a cage that I dont have to do any bending on..Thanks This Is For A 89 Notch Mustang..Cage Needs To Be Atleast A 10 Point!THANKS FELLAS:bigthumb
evil8
04-02-2013, 09:19 PM
Must be an LS1 swap if it needs a 10 point.
SN95N/A
04-02-2013, 09:19 PM
It most deffinately is.
evil8
04-02-2013, 09:23 PM
Maybe we need some input on a better quality one....thanks SBZ.
SN95N/A
04-02-2013, 09:38 PM
Guess I'm just get s&w cage does anyone have rough estimate weight between mild steel and chromoly in 10 point cage?
Maximus
04-02-2013, 09:39 PM
Wolferacecraft has pre bent/notched kits.
SN95N/A
04-02-2013, 09:43 PM
Thanks craig I will check that out
evil8
04-02-2013, 09:51 PM
CM will be about 60ish percent of the weight of the MS.
331lx
04-02-2013, 11:06 PM
Wolfe makes good shit as well as s&w
SN95N/A
04-03-2013, 09:09 AM
Thanks guys im give wolfecraft a call after work
bbfstanger
04-03-2013, 12:41 PM
you save about 30lbs on a cm 10 point vs ms
rmracing
04-03-2013, 03:46 PM
Go with Wolfe . I have used there kit and it fit like it was custom .
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.