View Full Version : FS: Sheetmetal Valve Covers
5.0calypso93lx
04-27-2012, 08:32 AM
I've got set of sheetmetal valve covers for a small block ford that are too tall for my application. They are the same exact valve covers I had on my old setup, but just as they come, not with these coil pack mounts welded onto them. The included hardware is a bit too short along the upper rail for the blue pre molded VC gaskets I run so you may also need to find 6 different bolts if you plan on using the same thickness gasket:
http://i446.photobucket.com/albums/qq188/bad306lx/IMG_2103.jpg
$60 picked up.
513-315-6583
aperacer
04-27-2012, 09:34 AM
ok. so no coil mounts correct. they would be smooth on top?
5.0calypso93lx
04-27-2012, 10:15 AM
ok. so no coil mounts correct. they would be smooth on top?
That is correct, it is these exact covers. No holes anywhere as I was just going to have some -10 fittings welded where I wanted them:
http://www.ebay.com/itm/Small-Block-Ford-FABRICATED-Aluminum-Valve-Covers-SBF-/251046991248?pt=Motors_Car_Truck_Parts_Accessories&hash=item3a73911590&vxp=mtr#ht_3334wt_1068
$95 after shipping is what I paid. These are brand new, only one has been mounted.
SLWB16hatch
04-28-2012, 07:42 PM
Where did u get ur alternator bracket? Sorry i know that's off topic.
5.0calypso93lx
04-30-2012, 11:07 AM
Where did u get ur alternator bracket? Sorry i know that's off topic.
That was an Aaron Price billet bracket. Had it for sale on here for a while but sold on Corral.
5.0calypso93lx
05-01-2012, 10:31 AM
You can kind of see them in this picture. These are the exact covers:
http://i446.photobucket.com/albums/qq188/bad306lx/IMG_4366.jpg
5.0calypso93lx
05-14-2012, 10:42 AM
Anyone need? These are some good looking valve covers on the cheap.
aperacer
05-14-2012, 12:29 PM
you have a pm
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.