TONYT
03-04-2012, 10:50 AM
installed my used aje kmbr,which was set up for coil-overs,took off the a-arms that were for coil-overs and replace with my stock ones for now,had to order the spring perches that went with this older version of the aje k mbr series,installed em and went to install the springs,here's where the problem comes.
the springs once seated in the cups and released to normal height are in a bind,bowed,not straight up and down as normal.
the spring perches seem to mount just under the square tubing of the kmbr where the two front mounting bolts attach it to the body.(line em up and tap two holes in the square tubing and secure with nuts bolts and such on each side.)
i talked with aje because the perches i ordered from summit didnt work and found out bout the diff. in kmbr designs,hence him sending me the right perches,its the springs binding thats got me twisted,any advice welcome
the springs once seated in the cups and released to normal height are in a bind,bowed,not straight up and down as normal.
the spring perches seem to mount just under the square tubing of the kmbr where the two front mounting bolts attach it to the body.(line em up and tap two holes in the square tubing and secure with nuts bolts and such on each side.)
i talked with aje because the perches i ordered from summit didnt work and found out bout the diff. in kmbr designs,hence him sending me the right perches,its the springs binding thats got me twisted,any advice welcome