EFI Spyder and a stock hood

[SCHMUCKINGHAM]

I bought Kenny's ( MustangBoy) old EFI Spyder/ modified Performer intake and while assembling everything on the stand I dont think this elbow will fit under my stock hood but I wanted to see what others are running or using to fit it under a stock hood. I already have ES mounts but the K member is stock.

[89notch]

http://www.intakeelbows.com/mustang.htm

Might need one of these

[Goober]

http://www.intakeelbows.com/mustang.htm

Might need one of these

If it'll fit a 9.5" Super Vic under a stock Fox hood than it should clear either with a stock hood. That Spyder EFI was a Vic Jr., right?


I'm hoping it'll clear an 8.2" Super Vic on the 94 with a 1" setback and 1.5" cowl

[SCHMUCKINGHAM]

If it'll fit a 9.5" Super Vic under a stock Fox hood than it should clear either with a stock hood. That Spyder EFI was a Vic Jr., right?


I'm hoping it'll clear an 8.2" Super Vic on the 94 with a 1" setback and 1.5" cowl

Honestly I cant remember, it was a carb intake modified to EFI

[SCHMUCKINGHAM]

http://www.intakeelbows.com/mustang.htm

Might need one of these

Holy looks expensive haha

[Timido]

If it was a 302 Intake from Kenny it should be a Victor Jr.

[mustangboy]

It would not fit under a stock hood on my car in fact I have a hole cut in my cowl hood to fit but I also had a 1" spacer on mine as well. Without the spacer it should have cleared the hood but not sure if it would have cleared the fuel rails. You could also look into the the edelbrock elbows I think they are approx $120 vs $225 for the sheetmetal ones. Good luck

[SCHMUCKINGHAM]

The EFI Spyder clears the rails without a spacer just fine but I dont think it will clear the factory hood at all.

[mustangboy]

Here is the link to Edelbrocks site so you can see what they have that may work for you. Surely one of the short ones will fit under a stock hood

http://www.edelbrock.com/automotive_new/mc/efi/intake_elbows.shtml

[SCHMUCKINGHAM]

Here is the link to Edelbrocks site so you can see what they have that may work for you. Surely one of the short ones will fit under a stock hood

http://www.edelbrock.com/automotive_new/mc/efi/intake_elbows.shtml

But will it clear the rails, thats the 150 dollar question LOL

[bennyboy]

i have one on my 95 it clears rails with no spacer but i have a cobra r hood

[Goober]

i have one on my 95 it clears rails with no spacer but i have a cobra r hood

More info please, such as what hood, intake manifold, block and mounts?

[SCHMUCKINGHAM]

More info please, such as what hood, intake manifold, block and mounts?

You read my mind

[TONYT]

i had that prob. so i took mine to my mach shop and had it cut down to fit