Long Block 347 Stroker Engine

[2Fast4You]

Block is CNC machined, Steel crank, H-Beam rods, 10.5:1 forged flat tops, billet main girdle,all ARP studs and bolts, Summit Racing balancer, TFS Hydraulic roller cam .574 In .594 Ex., double roller timing chain, aluminum water pump and pulleys, oil pan and ready to go. Not sure exact mileage but can only guess that it is minimal.

This engine was in a 1990 GT w/ full interior and stock suspension and was running 12.40's consistently on a bad tune. I am sure with a nice set of heads, intake and a good tune this motor is capable of running low 12's, high 11's.

A short block with this amount of money invested could easily cost someone 3.5K, I am asking $1950.00.

[Maximus]

You need to roll your Coupe out of the garage, snap a pic of it, and make it your new Avatar.:bigthumb

[2Fast4You]

You need to roll your Coupe out of the garage, snap a pic of it, and make it your new Avatar.:bigthumb

I agree, I am going to do that when it is getting loaded up on the trailer to get the cage installed.

[Pitbull1052]

I've got that much in machine work in mine good buy for someone glws

[2Fast4You]

I've got that much in machine work in mine good buy for someone glws

This is a great buy for someone.
Thanks

[2Fast4You]

Come on fellas, there has to be a winter project upgrade out there where someone needs a nice strong engine to replace that hi mileage stocker. Run low 12's or maybe even hi 11's easy w/ this at a fraction of the cost.

Shayne 513-519-8394

[2Fast4You]

Gone, Lock it up...