WTB/Back motor cover before flywheel

[mwaller5672]

I need the back motor cover that goes on before the flywheel. Stuck till I find one.
Mike

[5.0calypso93lx]

How are you stuck? I'm assuming you're concerned about the spacing of the starter, which you can shim out with similar sized washers if you can't find a block plate.

[mwaller5672]

I bought the motor with no back plate or clutch setup on it so I need it all including the bell housing. Check out this picture on this thread WTB/clutch setup for 5.0

[Goober]

I've got a spare, don't know what shipping would run ya.

[draggin50]

I've got one too that your welcome to have. I'll be at the SCS if that will help. 5.0,5 speed right?

[mwaller5672]

You guys talking just the plate or flywheel/clutch also. I will be in mt. orab friday. Is it close. And of course whats the price. Yes it's a 5.0. I still need to buy the transmission so it shouldn't be an issue. I want a 5 speed
Mike

[5.0calypso93lx]

I have one for $20 I'll sell ya and I'm not too far from Mt. Orab and I'll be home all day friday.

[mwaller5672]

Sounds good - I will take it. If anybody has anything else I need let me know. I need the whole setup including the clutch/flywheel setup and bell

[draggin50]

I have a stock flywheel and the plate that goes against the block. It was resurfaced and used for about 500 miles. I'd take $40 for them both.

[mrstang-gt-46]

i have one $10