electric fan install help on a 95 mustang gt

[turbostang95]

i am having to install a aftermarket fan on my 95 gt due to the factory fan not clearing the pulleys. I did the 89-93 ftont end conversion on it so i could run the march performance brackets. I have a electric fan from BE COOL that has two wires comming off of it, one is blue and the other is black. I know the black is ground and the blue is 12v +. I already ran the black wire but what is the best way to hook the blue wire up on my car?

thanks

[mustang8998]

I didn't read this whole article, but it has some diagrams. Hope it helps...

http://www.aaroncake.net/rx-7/efaninstall.htm

[turbostang95]

i was basically trying to find out if anybody knew if i could just jump it off of one of the wires on the factory fan harness, theres three wires on the harness, black, red and orange?

[turbostang95]

i found out what i was asking, for anybody that doesnt know, on the 94/95 cars for sure, you can run the 12v + wire on any aftermarket fan and tap it into the high speed wire which should be the orange/light blue wire and then run the ground wire to a good ground. thanks for all that helped