No Big Deal....

[80 hate]

Well I wish I could get on here and post about installing a procharger on a stroker motor but...... All Im doing is installing a new clutch. No big deal right? Well this is the first one I have ever done. I got the exhaust and X-Pipe off. The drive shaft out and Im ready to pull the trans from the bell housing tomorrow. Any tips you guys might have would be great. Like..The trans is held to the bell housing with four 15mm bolts. How do you get the top drivers side out. A wrench wont fit. I was going to drop the cross member and let the motor and trans sag a little to see if that gave me room???:confused:

[bandit'sgirl]

Id do the whole job for $150.00

[80 hate]

Well I have every thing out of the car. Now its time to start putting the new stuff in. Here is a shot of the old clutch bell housing and tranny.