View Full Version : 302 starters/Fly wheels
TurboNG
04-18-2011, 10:37 PM
Is there more than one tooth count for flywheels/starter that will bolt up to the 302?? I got a car that had no starter on it and the two starters i tryed in the car wont engage the flywheel...
Stangman
04-18-2011, 11:00 PM
Pretty much all of your foxbodys used a 157 tooth flywheel if its a stick I do believe
Pitbull1052
04-19-2011, 09:22 AM
not to state the obvious but are you sure the starters are good? I just put a motor back together that had a brand new starter this past october and some how it went bad over the winter just sitting........
TurboNG
04-19-2011, 04:57 PM
I've tried 3 starters now and i wouldn't think all 3 are bad.
Stangman
04-19-2011, 05:04 PM
All your ground straps bolted to the block and body proper?
Pitbull1052
04-19-2011, 05:07 PM
I wouldnt either, but also on mine my battery was low too so when i'd hit the key the starter would just spin..... and not engage even after I put the new starter on... charged up the battery and it fired right up
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.