Correct bolts for trick flow intake.

[2Kblacksleeper]

I need the bolts that go in the middle of the intake. The ones that hold the upper to the lower.
Looking to pick up soon.
Would cincy have these in stock?

Thanks for your help.

John

[2Kblacksleeper]

Just ordered some from summit.

No I'm not getting inpatient at all. Lol

After driving around some I want my damn car mobile.

[NXcoupe]

Sorry just saw this. I have quite a few laying around.

[Jeff88coupe]

You could of called Trick Flow's tech line. They sent me some for my old R intake and gaskets free when I called looking for how to order them.

[2Kblacksleeper]

Mike do you have any for the intake with the 1" spacer?

[CNTLOSE]

Wish you would have said something the other day. I have a set...but not for a one inch spacer...lol

[2Kblacksleeper]

I dont have the spacer yet, but in a month or two I will.
I'll need it with the new motor.

[2Kblacksleeper]

Thanks again Matt. I put the injectors and maf on yesterday. I didn't pull the dist either. Lol.
That front bolt is a pain in the ass.

[NXcoupe]

Mike do you have any for the intake with the 1" spacer?

I might have. I would have to see how far they stick out the bottom of the intake. Which intake do you have exactly? I have both kinds here, just want to make sure I check with the correct upper.

[5.0calypso93lx]

I think I also have one or two laying around. The longer ones that is. I went down to a 3/8" spacer instead.

[2Kblacksleeper]

I have the street intake.
Is the lower intake the same for all three uppers?
Like can I buy the box upper and it bolt to my lower?
I know my new motor will go to 7000 plus rpm, but I'm low on money.


My plan was to get k member and front suspension switched out when we swap motors and then upgrade intake later.
But if the box upper will bolt up then I might change my plan a little.

I figure if I'm going to spend 500 ish on an intake set up, why not just spend 150 more for k member, arms etc.
Then I'll up grade the intake in a month our two.

Sorry to be so long winded.
John

[CNTLOSE]

Just FYI when I bought my 3/4 spacer for my TFS kit it came with the new longer bolts....which is why I have the originals still.

[NXcoupe]

I have the street intake.
Is the lower intake the same for all three uppers?
Like can I buy the box upper and it bolt to my lower?
I know my new motor will go to 7000 plus rpm, but I'm low on money.


My plan was to get k member and front suspension switched out when we swap motors and then upgrade intake later.
But if the box upper will bolt up then I might change my plan a little.

I figure if I'm going to spend 500 ish on an intake set up, why not just spend 150 more for k member, arms etc.
Then I'll up grade the intake in a month our two.

Sorry to be so long winded.
John

No, the street and track heats are the same lower, the R is a completely different lower and upper.
I'll see if I have those, I have a track heat here to measure with.

Michael