AR-15 tool question

[facemelter71]

Any one around here have a set of GO-no-GO gages handy.Wanted to see if I could borrow them for the AR build I have going on.

[marauder]

I'll send my friend that built mine a message, He may have one.

[Dirtyd0g]

Any good website to learn about em? I just got one

[facemelter71]

Im on ar15armory.com right now.There was another forum I was tryin to get on,but they didnt want to send me a confirm e-mail,so I sent a meesage to the admin and told him not to worry about it.I think it was ar15.com.Good luck getting in there.

Alan,did you buy a full AR or some pieces to start a build? Im lookin for the gages so that I can assemble My own upper with my own Headspace measument.

[Dirtyd0g]

I bought a full AR-15, Bushmaster
I found out later I might have paid a bit much, my sources for value weren't very accurate when I looked it up. It is a very nice gun but I think I'd sooner shoot the SKS. .223 are expensive
Alan

[facemelter71]

Ive over come the expense of shooting .223 rounds by reloading my own.It is way cheaper than buying off the shelf.And I can monitor what im putting through my weapon.Bushmaster has always carried a higher price tag.They make great stuff.If you paid some where around 1k its not to bad.Ive seen a couple at gun shows go for either side of that figure.

[marauder]

No luck with my friend.

My AR is a Superior 556 lower w/9mm hammer, hahn block, RRA 9mm upper. Good times and cheap ammo.

[Dirtyd0g]

Ive over come the expense of shooting .223 rounds by reloading my own.It is way cheaper than buying off the shelf.And I can monitor what im putting through my weapon.Bushmaster has always carried a higher price tag.They make great stuff.If you paid some where around 1k its not to bad.Ive seen a couple at gun shows go for either side of that figure.
I guess I did ok then, want to make some rounds for me reasonably? I was really thinking about selling it because of ammunition cost.
Alan

[ibstrokin]

Check out aim surplus

http://www.aimsurplus.com/catalog.aspx?groupid=21

[facemelter71]

Actually ammo has come down in the past 2 months or so.But I can get you a figure on ammo.How much you needing?

[Dirtyd0g]

The link he posted seemed to be much better than what I was seeing. I just bought a bunch of 7.62x39mm and ended up paying 11 cents a round. On the same sight that I bought that .223 stuff was rediculous. I guess I just have so decide to keep this gun or sell it.....I want a .223 rifle with a good scope. The M16 look doesn't impress me.
Alan

[87stangbbb]

The link he posted seemed to be much better than what I was seeing. I just bought a bunch of 7.62x39mm and ended up paying 11 cents a round. On the same sight that I bought that .223 stuff was rediculous. I guess I just have so decide to keep this gun or sell it.....I want a .223 rifle with a good scope. The M16 look doesn't impress me.
Alan
where can i get 7.62x39mm for 11 cents a round?thanks

[Dirtyd0g]

I use ammoseek.com to find it, but it has been down the last few days, right now the best price I see is .16 a round