cms stage 2 cams

[silverstang]

I found a good deal on a set of stage 2 cms cams like the sound and gains. But my question is will i need to have fly cuts in the piston to clear the valves?
thanks lee

[cstreu1026]

No you don't need valve reliefs but you need to need to degree them as well check piston to valve clearance but to make sure. If they are too close you may be to retard the cams to get enough clearance. I had to retard my comp 270's 4.5 degrees to get enough.

[jeremy23]

Silverstang if you decide not to take them PM me and I will, looking for a good deal on these and since I am going to build a motor I wont have the PVC issue.

[silverstang]

Thanks I did not think I need to but wanted to make sure.
jeremy I was going to get them either way cause I can not pass them up 200 bucks. They are used but I know the guy that was runnin them. only reason he is getting rid of cause he went with a turbo set up and is getting a turbo grind