PA racing k member

[BlazinEagle]

Which one of the holes should I put my motor mounts through? The ones closer to the front of the car or the ones closer to the windshield? Right now I have it sitting in the front one and I cannot tighten it down because it is so close to the power steering lines?
I have never installed a motor myself so any input is appreciated. Also I am installing an explorer intake....which gasket set should I get for the lower intake? Which gasket maker is the best?
Thanks in advance!
-Rodney

[WARMACHINE]

Call Jason at PA Racing, I bet he would be happy to help. And good luck.

[bbfstanger]

the frt holes are stock position,or an inch setback.
black rtv works good for the ends,you can use the stk gaskets on the lower theyre the same opening.

[BlazinEagle]

Thanks for the info....I cannot use the back holes I found out because of my long tubes would be into the firewall. I guess I will have to use the stock hole and figure it out.