svtfox
01-21-2010, 07:41 PM
This dropout features a 4.6L engine with a T45 5-speed manual transmission! This engine produces 320 HP @ 6,000 RPM!
Up for auction is a 1999 Ford Mustang Cobra SVT 4.6L dropout with around 10k miles. The engine was purchased through Ford Motorsports as a crate package, then the used accessories from a 50k mile vehicle were added and it was installed into a custom application for only 10k miles of use. While this auction will include the engine, transmission, engine accessories, engine harness, air flow meter, engine computer, and shifter! This is the actual engine pictured you will recieve. This is one Cleveland Pick-A-Part's valued employee's package that we are selling for him, so even though this engine and tranmission package is fully spec'd as seen below we are not offering our company warranty.
This engine also has Steeda Underdrive Pullies, Steeda Aftermarket Shifter and Ford Motorsports Clutch and Flywheel setup.
Compression was a TIGHT 185 over 175: 1-185 2-175 3-185 4-175 5-180 6-175 7-175 8-180
Oil pressure was 90 pounds cold, and 60 pounds warm
Vacuum was a SOLID 19 inches
CO check PASS
i would like to get 4,300 out of this setup but im willing to work on the price a little. id work being willing to help install it too included in the price.
Up for auction is a 1999 Ford Mustang Cobra SVT 4.6L dropout with around 10k miles. The engine was purchased through Ford Motorsports as a crate package, then the used accessories from a 50k mile vehicle were added and it was installed into a custom application for only 10k miles of use. While this auction will include the engine, transmission, engine accessories, engine harness, air flow meter, engine computer, and shifter! This is the actual engine pictured you will recieve. This is one Cleveland Pick-A-Part's valued employee's package that we are selling for him, so even though this engine and tranmission package is fully spec'd as seen below we are not offering our company warranty.
This engine also has Steeda Underdrive Pullies, Steeda Aftermarket Shifter and Ford Motorsports Clutch and Flywheel setup.
Compression was a TIGHT 185 over 175: 1-185 2-175 3-185 4-175 5-180 6-175 7-175 8-180
Oil pressure was 90 pounds cold, and 60 pounds warm
Vacuum was a SOLID 19 inches
CO check PASS
i would like to get 4,300 out of this setup but im willing to work on the price a little. id work being willing to help install it too included in the price.