Rick93coupe
11-11-2009, 06:54 PM
I've got 2 sets of heads I'm not going to end up using.
The first set are 69 heads that I picked up from 93 Hulk. I'm going to use aluminum heads on my boat after all, so I won't be needing these. As listed by Mark, they have 2.02 / 1.60 valves in them and mild port work, 3/8" screw in studs and guideplates. They have surface rust on them and need cleaned up and looked at but are a hell of a deal at 100.00 firm. Valves, guide plates and studs are worth this amount.
The second set are from a running 95 truck motor with 89,000 miles. I'll need to pull them off the motor if you want them and you can have everything that goes with them for $50.00 firm.
Thanks,
Rick
The first set are 69 heads that I picked up from 93 Hulk. I'm going to use aluminum heads on my boat after all, so I won't be needing these. As listed by Mark, they have 2.02 / 1.60 valves in them and mild port work, 3/8" screw in studs and guideplates. They have surface rust on them and need cleaned up and looked at but are a hell of a deal at 100.00 firm. Valves, guide plates and studs are worth this amount.
The second set are from a running 95 truck motor with 89,000 miles. I'll need to pull them off the motor if you want them and you can have everything that goes with them for $50.00 firm.
Thanks,
Rick