good heads for a 351w non-roller?

[bobtsgt]

Right now I have a set of 1970 c09E heads that have some polish work done on the intake ports. Took them off to find a couple valve tips cracked and will most likely need a 3 angle to clean them up right along with some new valves. So I'm lookin for a good aftermarket as a back up plan if these are going to cost too much to redo. Not sure what works best for a carb hydro flat tappet cam combo.Car combo is..

1970 351w bored .30 over
Edelbrock RPM air gap intake
700DP Holley carb
274xe cam kit
msd distributor
all in a 83 GT 5 speed w/ a 3.73

[Timido]

I like Victor Jrs a lot. Check with Jeff to see what kinda heads he ran on his 347 they picked up quite a bit over his ported small AFR's. Somone else here mentioned N351 Circle track heads for a cast iron budget head they might fit you well. I would like to find some more info on them first.

Bob I still have some Flat Hydro stuff if you need any of it. http://www.stangbangerz.com/forums/showthread.php?t=53874

[bobtsgt]

thanks for the insight Tim. I did need that stuff last week. Didn't check the classified that far back before I ordered the new stuff. carp for me :HYF: