Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
install instructions [Archive] - StangBangerz Forums
PDA

View Full Version : install instructions


BlazinEagle
10-20-2009, 05:33 PM
Just picked up the powerdyne bd-11a off flaming87lx but I have never installed one of these before (never even had a supercharged car before). I cannot find instructions online anywhere.
This is going to be going on a 90GT.
Thanks,
Rodney
Goldeneagle
10-20-2009, 05:41 PM
I hope you're rebuilding the power plant, and did you get the brackets? If so then all the ones that I have seen and the one I had were on the right hand side. :)
Goldeneagle
10-20-2009, 05:56 PM
http://www.corral.net/forums/showthread.php?t=763402
facemelter71
10-20-2009, 06:09 PM
Install's on everything but a foxbody.
http://www.powerdyne.com/installation_manuals.htm
wildstang89
10-20-2009, 06:20 PM
Rodney, I think I may still have my instruction book for the one I have. I'll have to look for ya. Steve
BlazinEagle
10-20-2009, 06:59 PM
Steve that would be great...do you still want this beast of a compressor? If so I do not have my engine hoist anymore so we will need many guys to lift it.
The powerplant was rebuilt a couple years ago with low miles on it. It does not have any shaft play in it. And I need the instructions for a fox!!!! why the hell do they have everything else but that?
-Rodney
wildstang89
10-21-2009, 03:23 AM
I forgot all about it. lol My truck is down again though, so is the jeep.
I'll go out to Dad's and look for the instructions.