Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
King Cobra clutch kit ?? [Archive] - StangBangerz Forums
PDA

View Full Version : King Cobra clutch kit ??


Gearhead
07-18-2009, 05:40 PM
Did they change the Pressure plate on these kits recently ??

I just yanked mine out and it's been scraping against the bellhousing. I hope that explains part of the noise that's been coming from my clutch area.

I'm guessing these are probably now made in China ??!!
quik lx
07-19-2009, 11:08 AM
I had the same problem with one I installed for my neighbor. We just had to grind a couple places on the inside of the bell housing. I was pissed to have to pull it all back apart though. (esp after doing 7 or 8 of these with no problems in the past)

I went to the web site he bought it from and found the small print at the bottom saying "89 bell housings will need clearanced .020". I though all bellhousings were the same. I'm sticking with my SPEC units from now on.:mad: