Housing bushings.

[DeckerEnt]

Mine are shot and need just the 2 in the housing. Would prefer poly ones which I could just press into the original sleeves. I have a good set of upper and lower control arms on it with good bushings so I am hoping these will help my wheel hop issue. Let me know what you have. Thanks...

[92coupe]

Keith you can get the stock units from AutoZone or Advance, Craig got me a set of the poly units from Mac inc they are in Dayton look them up on the net.

[DeckerEnt]

Thanks Brian. Found them on Late model restoration's site. They are on the way.

[mustang8998]

Keith, spray the old ones well, with PB, WD40, etc.... It will help, when you go to knock them out.

Put the new ones in the freezer, for a few hours and they will practically fall in.

[DeckerEnt]

I was going to do the Shannon trick on them. Drill a ton of holes all around the center pin, pull pin out, then razor blade the rest of the rubber out of the sleeve. The ones I am getting are just the poly center and pin, well hole. I need to reuse my sleeves so I don't want to damage them at all. I will let you all know how it goes.