Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
Solid Motor Mounts [Archive] - StangBangerz Forums
PDA

View Full Version : Solid Motor Mounts


mustangbangher
05-05-2009, 08:39 PM
What does everybody think about ebay solid motor mounts? http://cgi.ebay.com/ebaymotors/96-04-FORD-MUSTANG-4-6L-SOLID-ENGINE-MOTOR-MOUNTS_W0QQcmdZViewItemQQcategoryZ50454QQihZ001QQi temZ110385922759QQrdZ1QQsspagenameZWDVW

Is there any way I could mod my stock mounts to make them solid?
Black Horse
05-05-2009, 09:54 PM
Why do you want solid mounts?
mustangbangher
05-06-2009, 10:06 AM
how I have my turbo set up my exhaust flexes the exhaust to much.....
Black Horse
05-06-2009, 10:45 AM
There is always good things and bad things about changes such as this. I would highly recommend going with a good known brand. Solid motor mounts see more stress than the flexible ones. You might consider urethane mounts as well - less movements but still dampens the vibrations.
I have seen folks add restricting bolts to keep there stock type units from flexing as well. Good luck!
mustangbangher
05-06-2009, 10:52 AM
What do you mean by restricting bolts?
Black Horse
05-06-2009, 02:57 PM
Running a bolt through the mount to "squish" the rubber and keep it from flexing as much.

Not a habit I would recommend, just have seen it done.
mustangbangher
05-06-2009, 06:10 PM
What could that hurt?
DeckerEnt
05-06-2009, 07:39 PM
If you drill a hole in something, you are weakening it! Especially if you are adding a ton more power. The motor mounts transfer all that power to the trans and rear end. Major stress point. Don't skimp on it!!!
dsmawd350
05-06-2009, 08:02 PM
add some flex sections in your hot side....
mustangbangher
05-06-2009, 09:46 PM
add some flex sections in your hot side....

I did but it rip a little whole in it... Kinda want to do away with the flex pipe.... rather have the motor mounted to the body plus it only gets about 2k miles a month if that..... And also want the engine to torque the car ( I think it will look cool) Any suggestions? Thinking about just squashing the rubber!!!!