k062693w
02-26-2009, 12:05 PM
OK... I hope someone can help me here.. :confused:
I did a bunch of reading online about welding the rear end to make it a true posi.. I did everything that was recommended, I did great welds, Installed the gear set in the pig, And installed it in the housing.. Everything went together like a dream.. It has been about a week since I did the install and have not touched the car since today. Well to make a long story short I put the wheels on this morning to move the car around in my garage, AND IT WON'T MOVE !!!!!! :mad: I have checked the brakes, Checked the emergency brake, And still nothing :mad:
The car doesn't have a driveshaft in it. Hell for that matter there is no Motor or Trans in it....
I have spent the better part of this morning trying to figure it out and I am about at the END OF MY ROPE !!!! I'm have tempted to pull the whole rear end and put a stock rear back in it..
Any Help would be appreciated...
Here are some pics to show that the welding was done properly and that isn't the cause....
Thanks in advance for any help..
:bigthumb
.
.
.
.
.
.
.
.
.
Here is the ring and pinion
http://i237.photobucket.com/albums/ff282/k062693w/weldedgear.jpg
Here it is installed in the pig
http://i237.photobucket.com/albums/ff282/k062693w/weldedgearhousing.jpg
I did a bunch of reading online about welding the rear end to make it a true posi.. I did everything that was recommended, I did great welds, Installed the gear set in the pig, And installed it in the housing.. Everything went together like a dream.. It has been about a week since I did the install and have not touched the car since today. Well to make a long story short I put the wheels on this morning to move the car around in my garage, AND IT WON'T MOVE !!!!!! :mad: I have checked the brakes, Checked the emergency brake, And still nothing :mad:
The car doesn't have a driveshaft in it. Hell for that matter there is no Motor or Trans in it....
I have spent the better part of this morning trying to figure it out and I am about at the END OF MY ROPE !!!! I'm have tempted to pull the whole rear end and put a stock rear back in it..
Any Help would be appreciated...
Here are some pics to show that the welding was done properly and that isn't the cause....
Thanks in advance for any help..
:bigthumb
.
.
.
.
.
.
.
.
.
Here is the ring and pinion
http://i237.photobucket.com/albums/ff282/k062693w/weldedgear.jpg
Here it is installed in the pig
http://i237.photobucket.com/albums/ff282/k062693w/weldedgearhousing.jpg