View Full Version : porting work??
Jrcmutang
01-19-2009, 11:42 AM
I have a 351 trick flow "R" series intake, and I was wondering if anyone knew of a place where i could get the runners ported? I would like to find a place where i could have it done without having to cut the intake in halfo to get down inside of the runners? Also just curious about the cost?
tdm309
01-19-2009, 11:48 AM
Talk to rscoupe on here he does real good port work.
PaulFiveOh
01-19-2009, 03:08 PM
Give me a chisel and a hammer and some 40 grit metal sand paper, I'll get you all fixed up.
Rick93coupe
01-19-2009, 03:30 PM
What heads are you working with? The R intake flows pretty damn good as cast.
Jrcmutang
01-19-2009, 04:09 PM
I am running a prted set of performer RPMs, a little small i know for a 351 but eventually going to up grade to like AFR 225
Jrcmutang
01-19-2009, 04:10 PM
a hammer and some sand paper?? WOW thats hands on lol
Jeff88coupe
01-19-2009, 04:56 PM
We may also want to call BES http://www.besracing.com/ . They just out in St. Leon, IN...hard to beat their work. I had my tfs-r lower intake port matched to my ported AFR 185 head intake runners. To bad the guy that did my work isn't in business anymore.
PaulFiveOh
01-19-2009, 06:37 PM
a hammer and some sand paper?? WOW thats hands on lol
Haha :D
Jrcmutang
01-20-2009, 09:50 AM
Thanks for the link, i am going to look into it. I am eventually going to go with a turbo or a blower so i was looking to free up some ponies till then... lol never ending battle with money
mustang3091
01-20-2009, 11:56 PM
Hey is paul a computer guy
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.