Svo R block 418, brodix neal, billet

[Blowpastyou]

SVO R block, has been sitting un-assembled for a while so it needs a finish hone to take care of some corrosion in the cylinder. Have measured the cylinders there is room to go up to 3 thous. to clean it up. Billet Crank, Billet rods, 2 sets of pistons, set of 14.5to1 pistons, and the other are brand new 8.5to1 bennet pistons with tool grade pins. internally balanced. The block was setup to be dry sump but can be put back to wet sump very easy.

Heads, Brodix Neal BF202 fully hand ported, titanium valves, titanium retainers, 1 new set of triple valve springs that are 400lb on the seat and almost 1000 at 1.00 of lift, coil bind at 1.350, and another set of springs retainers and locks but im not sure what they are. Both sets are solid roller springs.

Im asking $5000 for all. For anyone that knows what this stuff is, it would cost BIG money to duplicate.

http://i211.photobucket.com/albums/bb78/blowpastyou/stuffforsale004.jpg

http://i211.photobucket.com/albums/bb78/blowpastyou/stuffforsale005.jpg

http://i211.photobucket.com/albums/bb78/blowpastyou/stuffforsale006.jpg

http://i211.photobucket.com/albums/bb78/blowpastyou/stuffforsale008.jpg

http://i211.photobucket.com/albums/bb78/blowpastyou/stuffforsale003.jpg

[93 coupe]

Do you have any flow #'s on the heads? Also were they repaired at anytime?

Are the crank and rods new? Thanks

[Blowpastyou]

the heads flow 400 and 305 at .800, and I think the crank is new, and the rods had very little use. The heads do not appear to have any repairs at all.

[Blowpastyou]

I was in a hurry last nite when I posted this, I can explain some more stuff now. The Block# is E32M-6015-A351. The bore size now is 4.1235. The low compression bennet pistons are 4.165 with a recommended ptwc of .010 so there is more than enouph room to torque plate hone. The rods are Carrillo with carr sps bolt upgrade.

[Blowpastyou]

ttt...........

[Blowpastyou]

Need to move this setup! Hell, there is over 2 grand in valves in the heads!! Make an offer! Trades???

[Blowpastyou]

Alright I had a guy over on NMRA forums correct me on the cylinder heads. They are Yates C3 heads. Not brodix neal's. They are still BIG MONEY cylinder heads. They have 2.16 ti intake valves and 1.65 ti exhaust valves.

[Gregg@TFS]

Reguardless this is a great deal for anyone with the cash!!!!

Good luck on the sale. :bigthumb If I had the money I would buy it.

[Blowpastyou]

Thought id add that this comes with 2 sets of valve springs, 2 cams, a msd pro billet 2 wire dist., and 1.7 crane gold rockers.

[Bowers]

What are the cam specs?

[Blowpastyou]

sorry, this is no longer for sale..