Turbo Oiling Question

[Badfbdy]

I want to run a "T" AN fitting http://www.jegs.com/p/Russell/756595/10002/-1/10019 where the chevy oil pressure sensor goes in the back. Then hook my two -4 turbo oil feeds to it.

My question I know the oil pressure will be around 30-50psi is that good enough to supply two -4 oil feeds through the -4 out of the block? The turbos have no oil restrictors in them.

[93hulk]

If you are going to run a -4 from the T. I would think you would need more supply to the T. Like maybe a -6 to the T then go to -4. Just my opinion.

[Walter]

I want to run a "T" AN fitting http://www.jegs.com/p/Russell/756595/10002/-1/10019 where the chevy oil pressure sensor goes in the back. Then hook my two -4 turbo oil feeds to it.

My question I know the oil pressure will be around 30-50psi is that good enough to supply two -4 oil feeds through the -4 out of the block? The turbos have no oil restrictors in them.

You should run an inlet restrictor on your turbo's. That being said, I think the setup you outlined above will be fine. I run a restrictor from function7 http://stores.ebay.com/Function7-Engineering

[Badfbdy]

Ya Ackbar (everyone's fav) runs those on his. Those function 7 are the best I have their oil drain on mine.