Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
Fox headers on a 94 GT? [Archive] - StangBangerz Forums
PDA

View Full Version : Fox headers on a 94 GT?


5.0calypso93lx
06-29-2008, 11:43 PM
Will fox body headers, specifically FRPP GT40P's, fit on a 94' GT? I picked the car up today and there is a hole in the driver side header. Thanks.

Also, this car is not using the EGR.
Rick93coupe
06-30-2008, 01:17 AM
I'm thinking that they would physically fit, but isn't there some smog bullshit on the 94-95 headers that make them specific? Not that it would probably apply.
RACEME
06-30-2008, 08:23 AM
If you ditch that egr tube, they are the same. How do you have the EGR removed? You kind of have to trick the egr valve for it to run correctly. I have done this on my 95.
5.0calypso93lx
06-30-2008, 10:45 AM
If you ditch that egr tube, they are the same. How do you have the EGR removed? You kind of have to trick the egr valve for it to run correctly. I have done this on my 95.

I honestly have no idea how it is setup right now. I'm going to check it out thursday, when I'm dropping the trans to replace the rear main.

I do know that there isn't a tube running to the header right now though, and the h pipe also has the EGR tube flattened and welded up.
RACEME
06-30-2008, 11:04 AM
The egr valve itself should still be attached and laying behind the throttle body unless it has some sort of chip/tuner that turned the egr code off. If the valve is there, you just have to rig it for the plunger to be 1/2 way in/out. A peice of fuel line, small bolt and a couple hose clamps works well for most of us.
347sc
06-30-2008, 12:16 PM
I did that on my orange car. Worked fine. You can find the EGR mil elims on ebay for around $20 last time I looked. Just plug it in.