Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
Caster camber plate question. [Archive] - StangBangerz Forums
PDA

View Full Version : Caster camber plate question.


DeckerEnt
06-18-2008, 12:22 AM
I just put the caster camber plates on my coupe tonight. I think they need to come off. The 3 bolt part that goes through the bottom was a tight fit. Which hole should I enlarge to get some more play in the plate? I am thinking of drilling out the single hole a little. Or should I grind on the 2 slotted holes? Keep in mind this is an 81 coupe. Not an 87-93.
Keith
DeckerEnt
06-19-2008, 12:04 AM
Well, I grinded the single hole out a bit and now there is enough play that it swings fully. Couldn't find a large enough drill bit so I put a grinding stone on my whiz wheel and just ground it till it fit.
Keith
Timido
06-19-2008, 06:14 PM
I dont think it matters which hole you drill out The alignment specs tell the whole story.