Rich
06-01-2008, 05:59 PM
It is a billet core, hydraulic roller cam designed/cut by Jay Allen. It is for a 302-310 cubic inch, manual trans, carb'd set up. 1.7 rockers are preferred. Will idle at 750 rpm, and pull 13.1 inches of vacuum(power brake friendly).
On a completely stock shortblock, I had to retard it 2 degrees to get intake valve clearance. With it "straight up" it was around .070.
213/227 @ .050
552/552 lift
108 lobe seperation
6800 starting shift point
These will require a spring upgrade(most likely).
$400 new from Jay.
$125 (exactly what I paid for it)
richtaylor344@earthlink.net
On a completely stock shortblock, I had to retard it 2 degrees to get intake valve clearance. With it "straight up" it was around .070.
213/227 @ .050
552/552 lift
108 lobe seperation
6800 starting shift point
These will require a spring upgrade(most likely).
$400 new from Jay.
$125 (exactly what I paid for it)
richtaylor344@earthlink.net