Oil in the intake manifold/burning oil heavily

[somedude56]

While I had my intake manifold off I noticed there seemed to be alot of oil in it, there was so much it came out in a small but steady stream. I replaced the pcv valve in it and the problem is still going on. Does anyone have any suggestions on this? I also had a bolt hole strip out on my aluminum lower intake manifold and I was wondering what alternatives I have to fix that.

Thanks alot for the help

Joey

[rsmurf04]

retap your lower and sound like there might be a vac problem concerning your oil in the intake.

[fst 5pto]

Also make sure all your gaskets are good and bolts are tight...

[somedude56]

Yea Im gonna retap it tomorrow but It was still burning oil from before it was stripped, are there any vaccum diagrams of mustangs floating around the internet?

thanks for the help guys

[graysonracin]

By chance if you just built the motor, did you put the small oil galley plug in the block .It sits on the back of the block under the intake, right where the pcv valve is. Friend didnt put one in his and it pulled alot of oil into the intake. Also the filter in the intake under the pcv might be bad.:bigthumb