Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
machined 351W block and 351 parts [Archive] - StangBangerz Forums
PDA

View Full Version : machined 351W block and 351 parts


csastocker
03-25-2008, 08:15 PM
I have a completely machined 351W block. It is a 70's block. Has been cleaned, bored 4.04, zero decked, align honed, honed with plate, and has new cam bearings installed. Sold rotating assembly and decide to go to a 302 based engine instead. $500 worth of machine work done. Sell for $400. Also have 351W used short block (.040 over) that is and early 70's block. $150. Also have 351W DOOE heads, $75. Looking for T5 setup and the typical 5.0 bolt on stuff so may trade for any or all of this stuff.
Thanks
Shawn
TONYT
03-25-2008, 08:25 PM
got a t5 in my 90 thats got to come out u might be interested
csastocker
03-28-2008, 12:39 PM
Got a T5 setup now. Could use the room in the garage. Sell everything for $400, that's a fully machined ready to go block, and a used early 70's 351W short block, and a used set of DOOE heads. Would trade for good rebuildable set of GT40 heads.
csastocker
04-09-2008, 08:41 AM
Dropping prices. Need some room in the shop now. The machined block I will sell for $300. It is a steal for someone building a 351W. Machine work is top notch. Also on the used '69 short block, $100. The DOOE heads, $75. Take it all for $400.
Thanks
Shawn
A05C
04-09-2008, 06:34 PM
im interested in the shortblock. where are you located?

i'de have to do a little saving up since i just bought my mustang today
csastocker
04-09-2008, 10:58 PM
I am located in Xenia near Dayton.
Thanks
Shawn
A05C
04-11-2008, 06:27 AM
i can possibly arrange something for next saturday. let me talk to some people and i'll find out more.
im interested in the shortblock and the t-5 setup. any more info would be greatly appreciated

i'll pm you soon and we can talk more about it.
5.0calypso93lx
04-11-2008, 11:50 AM
Whats the casting number on the 70's block? I'm still interested if its D0OE through D4OE.
csastocker
04-11-2008, 01:34 PM
The machined block is later. It is actually an E block so it is an 80's block. I got it confused with another block I have. The short block is a C9. The D0 and the C9's are the same, thicker webs and a 9.480 deck.
5.0calypso93lx
04-11-2008, 01:53 PM
The machined block is later. It is actually an E block so it is an 80's block. I got it confused with another block I have. The short block is a C9. The D0 and the C9's are the same, thicker webs and a 9.480 deck.

OK cool, I'm going to stick it out for either a 69-74 block or roller. I was under the impression that only the 69's were the 9.48" deck, while the 70-74's were the 9.5"?