wolverine8490
12-26-2007, 09:36 AM
I am selling my 306 that was built by Monarch Machine shop back in July. Engine has been driven 100 miles since the rebuild. Below is what has been done:
302 Mountaineer Block bored .30 over
New Cam, Rod, and Main bearings installed
ARP Rod Bolts
Crank turned .10 on the mains and the rods
Rods reconditioned
Hypereutectic Pistons
Approximate compression 9.08:1 with a 58.2cc head.
New Oil Pump
Replaced Freeze plugs
I have about 900.00 invested in the short block, and am looking to get 600.00 with no cam. Add 120.00 for the cam which is a TFS stage one, and an extra 40.00 for the TFS Billet Timing Chain set if desired.
302 Mountaineer Block bored .30 over
New Cam, Rod, and Main bearings installed
ARP Rod Bolts
Crank turned .10 on the mains and the rods
Rods reconditioned
Hypereutectic Pistons
Approximate compression 9.08:1 with a 58.2cc head.
New Oil Pump
Replaced Freeze plugs
I have about 900.00 invested in the short block, and am looking to get 600.00 with no cam. Add 120.00 for the cam which is a TFS stage one, and an extra 40.00 for the TFS Billet Timing Chain set if desired.