czwalga00gt
09-21-2007, 01:40 AM
My car is on ebay but I doubt ill get what I want so I'm parting it out. If you have a stock rear end and want to upgrade this is probably the easiest way to do it. Get the two cars together and just swap axle tubes; shouldnt take more than a few hours.
What you get for the swap...
- Auburn Electronic Locking differential (switch from posi to spool)
- Moser 31 spline forged axles
- FRP 3.73 Gears (No whine)
- FRP Girdle
- All new bearings and axle seals
Would do these seperate from the above swap but i'd like to get rid of all of it at once:
- MM Lower control arms
- Strange 10way adjustable struts
I'll help or do the swap for nothing... $0 labor. :bigthum: Also not sure what i'm looking to get, but all of it is only 3 months old (i'm a dumbass basically) and new it's about $2000 for everything.
What you get for the swap...
- Auburn Electronic Locking differential (switch from posi to spool)
- Moser 31 spline forged axles
- FRP 3.73 Gears (No whine)
- FRP Girdle
- All new bearings and axle seals
Would do these seperate from the above swap but i'd like to get rid of all of it at once:
- MM Lower control arms
- Strange 10way adjustable struts
I'll help or do the swap for nothing... $0 labor. :bigthum: Also not sure what i'm looking to get, but all of it is only 3 months old (i'm a dumbass basically) and new it's about $2000 for everything.