Roof section - factory sunroof

[SATURNV]

Hey folks, I'm looking for a factory sunroof roof for a F100 project. Don't need the glass, but if you have it I'll take it. I can due the cutting if needed, just need 110V outlet.

Thanks, Bob

[Carl]

I may have a roof section for ya, but you gotta wait until I come home in Oct.

[SATURNV]

Hey Carl, I can wait. :) Thanks, Bob

[SATURNV]

Still looking..

[Carl]

You still want me to cut my roof up for ya? I will post a pic of it in the next few hours. How much you willing to pay for it, plus where are you located?

[SATURNV]

Sure...

With or without glass??

I'd be willing to go $100 with glass. Located in Kettering.

Thanks, Bob

[Carl]

Sounds good, I will take pics you can let me know how much of the roof you want.

[SATURNV]

Cool. Awaiting pics. Where are you located and when would it be available? Thanks, bob

[Carl]

I will give you glass with it, though the seals are rough. Here is the pic for you, use MS Paint or whatever to mark where you want me to cut it.
http://pic80.picturetrail.com/VOL847/1728444/5242346/283683800.jpg

[SATURNV]

http://i217.photobucket.com/albums/cc155/EATONBU/roof.jpg

Cut the A pillars at the weld seam, the B pillars at the top, and across the roof where the side glass angles down toward the tail.

When do you think you will have a chance to have it cut?

Thanks much, Bob

[Carl]

Well, I will cut it sometime this weekend probably. But I won't be in town until next Saturday the 27th. I am in NC, but stay with family in Independence, KY while visiting them. Where you located?

[SATURNV]

My son has eye surgery on the 27th, will you be available on the 28th?

Kettering, just south of Dayton.

Thanks, Bob

[Carl]

Should be. I will get in touch with you as it gets closer.

[SATURNV]

Works for me. Thanks.

[Carl]

I cut it up today, but I couldn't get as low as you wanted with out removing glass. But here is a pic of it.
http://pic80.picturetrail.com/VOL847/1728444/5242346/284528249.jpg

[SATURNV]

Thats perfect. I figured it would be easiest for you to cut at the pillars, but since you look to have a plasma cutter.. ;) Let me know when your available for me to pick it up. Thanks again, Bob

[Carl]

I used a 4 1/2" cut off wheel to get it off. Got it done a little quicker than I thought too. If you want, PM me your number and I will get in touch with you after I get into town.

[SATURNV]

PM sent. Bob