D80E Heads

[Trey87stang]

Can anyone tell me if the stock valvetrain on these heads will support a trick flow stg 1 cam.

[Trey87stang]

Can anyone tell me. The cam is a .510 lift

[dedpedal]

If those have press in studs for the rockers, I wouldnt try it. either have the heads drilled and tapped for screw in studs or machined for bolt down.

[JonS]

I am pretty sure that the press in studs would pull out in short order. I am 99% sure that the springs won't be up to the job unless someone has replaced them. So if you figure $150-$200 for screw in studs and machining and $100 in valve springs, you have way too much money in a set of crappy heads. Nobody wants to hear it , but for a few hundred bucks more you could buy some decent used heads. If they have screw in studs already then go for it, but I would still make sure the valve springs are up to the task.

[Trey87stang]

Thanks for the input sounds like i won't be installin them.