351W Retrofit hyd roller cam

[Paul408Notch]

Lunati custom grind cam for 351W hydraulic roller retrofit. If you have a non-roller 351W block, running this cam allows you to use stock 5.0-style lifters instead of the $450 link-bars. I pulled this one out of my car a few months back. 2 of the lobes have a little bit of wear on them, but it still worked and ran fine. You could probably even have it re-ground if you wanted to. The core alone for this cam I believe is well over $100. You HAVE to run either a bronze gear or a Comp Cams Plastic gear. The lift written in on the cam card is with 1.7 rockers, the lift printed is with 1.6. This cam is over $250 new.

$50 +shipping.

http://www.paultown.com/ForSale/CamFull.jpg

http://www.paultown.com/ForSale/CamClose.jpg

http://www.paultown.com/ForSale/CamCard.jpg