Z cam

[YouGotJunk]

I have a Z cam for a 5.0 forsale...good condition....100bux...will trade!!!

specs:
Duration: 228°/228° @ .050''
Lift: .552''/.552''

[mailman]

You have a PM

[YouGotJunk]

bump bump bump......TTT!!

[Stangman]

might know a guy interested... lemme get ahold of him...

[YouGotJunk]

bumpity bump!!!

[dawsin94cobra]

i have an f cam in my stang now.. will it go right in?

[mustangrfast88]

no it will not work there is to much lift inless you got aftermarket pistions

[dawsin94cobra]

damn.. i have forged pistons?? will that work

[mustangrfast88]

it depends how much they are fly cut and with any cam change you should always check pistion to valve clearance anyways because what might work in one engine wont work in another

[Black Hole]

mustangrfast88, stay out of threads in the classifieds if you are not interested in the parts.

This is not the place for personal crap.

[mustangrfast88]

ok no problem

[dawsin94cobra]

How would I check that?

[mailman]

Modeling clay on the piston, pop on a head, turn the crank 2 revolutions with a breaker bar on the ballancer bolt, pull the head back off, then measure the thickness of the clay on the piston. With a head gasket, .100" is the lower safe limit. With no gasket, add the thickness of your gaskets to .100" to get your lower limit.



Still waiting on a reply to the PM...

[YouGotJunk]

PM replied....Quite a few people interested...first one to show me the money gets it!!!!!!!

[YouGotJunk]

TTT!!!!

[black90lx]

if i knew it would clear with my trickflow heads and stock pistons i would buy it :(