Silver Bullet
06-10-2007, 12:25 PM
Well I started the conversion yesterday. I started under the dash. The goal: to get the brake pedal out drill a hole for a rod in a different location for the master cyl. rod. Well after being in an awkward position, finding the bolts and correct wrench sizes, sqeezing my hand up in my dash and cutting my wist several hundred times until it was rubbed raw.... I got the bolt loose. Next, to pull out the b.p., I was frustrated as heck, pulling, tugging and then it happened, it finally came out, nailing me in the head right above my brow. My wife was there, and suggested urgent care, as it looked deep. Nope, just get me a bag of ice, so I can continue. Well after another while I finally get it back in and together to find a bushing in the floor. So now I have to take it back apart. So I then take it apart again, put it back together.... not that easy, yes it was a struggle again. Next to get the bolts in the plate for the mastercyl...... All went well all except the top left bolt, it was a Pain to get anything on it to tighten it up, but I did.
Today, back out to change the front brakes.....
Today, back out to change the front brakes.....